Product ID:PHILLYCLAD 6470 HARDENER
MSDS Date:06/02/1988
FSC:8040
NIIN:00N025603
Kit Part:Y
MSDS Number: BMCPP

ITW-PHILADELPHIA RESINS CORP

130 COMMERCE DR
MONTGOMERYVILLE, PA 18936
US

Emergency Phone: 215-855-8450

Info Phone: 215-855-8450

Cage: IO181

ITW PHILADELPHIA RESINS

MONTGOMERYVILLE, PA 18936 US

Telephone: 215-855-8450

Cage: IO181

POLYAMIDE RESIN; (EPOXY RESIN HARDENER- POLYAMIDE RESIN).

CAS: 68410-23-1

FURFURYL ALCOHOL

CAS: 98-00-0

RTECS: LU9100000

OSHA PEL S, 50 PPM/15 STEL

ACGIH TLV: S,10 PPM/15STEL;9293

KAOLIN

CAS: 1332-58-7

RTECS: GF1670500

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 2 MG/M3 TDUST; 9293

SILICA GEL; (SILICA, SILICON DIOXIDE (AMORPHOUS)).

CAS: 112945-52-5

RTECS: VV7310000

OSHA PEL 6 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

SHLD BE REMOVED & DESTROYED. REMOVE CONTAMD

RTECS: 9999999ZZ

CLOTHING BEFORE REUSE.

RTECS: 9999999ZZ

LD50 LC50 Mixture:SEE INGREDIENT 1.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN: CAN CAUSE DRYNESS, IRRIT & POSS
SENSITIZATION. EYE: PROD IS LOW IN VOLAT, HOWEVER EXCESS HEAT MAY
GENERATE VAPORS OF FURFURYL ALCOHOL WHICH CAN CAUSE IRRIT OF EYES.
EYE CONTACT W/FURFURYL ALCOHO L HAS BEEN REPORTED TO CAUSE
INFLAMMATION & CORNEAL OPACITY. INGEST: MAY CAUSE GI DISTRESS,
IRRITATION (SUPP DATA)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:EXCESSIVE EXPOSURE MAY RESULT IN IRRITATION OF
THE RESPIRATORY TRACT. CHRONIC: PROLONGED OR REPEATED EXPOSURE MAY
CAUSE ASTHMA AND SKIN SENSITIZATION OR OTHER ALLERGIC RESPONSE.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN ALLERGIES MAY
INCREASE CHANCES OF DEVELOPING INCREASED ALLERGY SYMPTOMS FROM
EXPOSURE TO PRODUCT. PRE-EXISTING SKIN & EYE DISORDERS MAY BE
AGGREVATED BY EXPOSURE TO THIS PRODUCT.

First Aid:EYES: IMMED FLUSH EYES W/PLENTY OF WATER FOR AT LEAST 30
MINUTES WHILE HOLDING LIDS OPEN. GET MED ATTN. SKIN: IMMED REMOVE
CONTAMD CLTHG. WIPE EXCESS FROM SKIN & FLUSH W/PLENTY OF WATER FOR
AT LEAST 1 5 MINS. USE SOAP IF AVAIL/FOLLOW BY WASHING W/SOAP &
WATER. GET MED ATTN IF EFTS DEVELOP. INHAL: REMOVE VICTIM FRESH AIR
& PROVIDE O*2 IF BRTHG IS DFCLT. GET MED ATTN IF EFTS OCCUR. (SUPP
DATA)

Flash Point Method:TCC
Flash Point:170F,77C
Extinguishing Media:FOAM, DRY CHEMICAL, CO*2.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY RUPTURE WHEN
EXPOSED TO HIGH HEAT.

Spill Release Procedures:AVOID PERSONAL CONTACT. SCRAPE UP AS MUCH
MATERIAL AS POSSIBLE AND PLACE INTO SUITABLE CONTAINERS LABELED FOR
WASTE DISPOSAL. RESIDUE MAY BE REMOVED WITH A SAFETY SOLVENT.
DISCARD CONTAMD LEATHER ARTI CLES SUCH AS SHOES AND BELTS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN COOL, DRY PLACE W/ADEQ VENT.
KEEP AWAY FROM OPEN FLAME & HIGH TEMPS. AVOID ALL SKIN CONTACT &
BRTHG OF VAPORS.
Other Precautions:AVOID PROLONGED OR REPEATED INHALATION OF HEATED
VAPORS OR SPRAY MIST. AVOID PROLONGED OR REPEATED SKIN CONTACT.
KEEP AWAY FROM HEAT.

Respiratory Protection:NIOSH/MSHA APROVED RESPIRATORY PROTECTION
REQUIRED IN ABSENCE OF PROPER ENVIRONMENTAL CONTROL. FOR
EMERGENCIES, A NIOSH/MSHA APPROVED SCBA OR FULL FACE RESPIRATOR IS
RECOMMENDED.
Ventilation:BRTHG OF VAPS MUST BE AVOIDED. VENT MUST BE SUFFICIENT TO
CNTRL VAPS. WHEN WORKING IN CONFINED AREAS, LOC VENT REQD.
Protective Gloves:IMPERVIOUS RUBBER/PLASTIC GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:SAFETY SHOWER & EYE WASH FOUNTAIN SHOULD BE
AVAILABLE. WEAR CLEAN LONG LEG & SLEEVED CLTHG. CONTAMD LEATHER
(SUPP DATA)
Work Hygienic Practices:PRACTICE GOOD HOUSEKEEPING. WASH THOROUGHLY
AFTER HANDLING, & BEFORE SMOKING, EATING OR USING TOILET
FACILITIES.
Supplemental Safety and Health
HLTH HAZ: OR ULCERATION. INHAL:PROD IS LOW IN VOLAT. EXCESS INHAL OF
VAPS MAY CAUSE IRRIT TO EYES, NOSE & THROAT; HDCH, NAUS. INHAL HAZ
OF FILLERS ONLY APPLIES IF CURED MATL IS GROUND/MACHINED TO PRDC E
DUST. FIRST AID PROC: INGEST: CONTACTMD IMMED. OTHER PROT EQUIP:
ITEMS SUCH AS SHOES, BELTS & WATCHBANDS (ING 5)

HCC:V4
Boiling Pt:B.P. Text:480F,249C
Vapor Pres:0.01 @ 20C
Spec Gravity:0.96
Evaporation Rate & Reference:NON-VOLATILE (BUAC=1)
Solubility in Water:NIL
Appearance and Odor:BLACK LIQUID, SLIGHT AMINE ODOR.
Percent Volatiles by Volume:NONVOL

Stability Indicator/Materials to Avoid:YES
ACID, OXIDIZING MATLS, MINERAL ACIDS & EPOXY RESINS UNDER UNCONTROLLED
CONDITIONS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CO, CO*2, NO*X.

Waste Disposal Methods:DISPOSE OF I/A/W FEDERAL, STATE AND LOCAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.